Now you can get a complete Edelbrock E-Force supercharged Coyote engine for your Ford project vehicle. The core of this engine is a brand new Ford aluminum block built for high performance applications. The lightweight aluminum block features a forged and balanced crankshaft, forged Manley H-Beam connecting rods and Mahle forged aluminum pistons. This crate engine produced 785 hp and 660 ft-lbs. of torque at the flywheel when tested at the Edelbrock dyno facility. The 9.5:1 compression ratio allows for safe and reliable supercharged performance on 93 octane pump gas. Helping this engine breathe is the Edelbrock E-Force supercharger system. This great looking system features Eaton TVS R2650 rotors, which provide unparalleled efficiency, whisper quiet operation and OEM reliability. This engine package comes complete with essential supercharger kit components, such as the electric intercooler water pump, intercooler plumbing and intercooler recovery tank, as well as fuel rails, 60 lb/hr. fuel injectors, coils, mass air flow sensor (MAFS) housing and re-usable air filter. Includes all front end drive accessories: water pump, alternator, idlers, tensioners, belts and hardware. Pair with universal heat exchangers for a complete installation. Visit Edelbrock.com for a complete listing and more information on our universal heat exchangers. This engine is the ultimate solution for the Ford enthusiast transplanting a Coyote powerplant into their project vehicle. It includes a complete engine with an E-Force Supercharger system installed, wiring harness, pre-programmed ECU, electronic throttle pedal, oxygen sensors, MAFS, OBD-II diagnostic port, air filter, fuse box, water pump, hose, alternator, belts, idlers and hardware.